Western Digital Ultrastar ScaleUp SE4U102 User Manual page 139

User Guide
Figure 134: Rear Screws Installation
Option2: Using a Long T15 Torx Screwdriver, install the screw plate to attach the rear cover
alignment bracket and the rear rail to the rack posts. The screw locations are shown in the
following image. Tighten the rail screws to 3.38-3.61 Nm / 30-32 in-lbf.
Caution: Be careful to set the screws properly in the cover alignment bracket
and rail to prevent crossthreading.
3. Support
3.8 Rails Replacement
123