Configuring Oobm Static Ip Address Using Curl - Western Digital Ultrastar ScaleUp SE4U102 User Manual

User Guide
•
Gateway
Viewing the OOBM Network Configuration
Step 2 : To view the OOBM network configuration, enter the following:
sg_wr_mode <dev> --dbd --page=0x23,0x01
This returns:
e3,01,00,30,03,00,00,00,<IOM A
A Netmask>,<IOM A
IPaddr>,<IOM B
•
<IOM>
•
<IOM A Setting>
•
<IOM A IPaddr>
• <IOM A Netmask>
•
<IOM A Gateway>
•
<IOM B Setting>
•
<IOM B IPaddr>
•
<IOM B Netmask>
•
<IOM B Gateway>
The result, after setting the two static addresses in
(page
e3,01,00,30,03,00,00,00,00,00,00,00,C0,A8,00,0A,FF,FF,FF,00,C0,A8,00,01,
00,00,00,00,C0,A8,00,0A,FF,FF,FF,00,C0,A8,00,01 <dev>
The result, when IOM B is not booting (no IP):
e3,01,00,30,03,00,00,00,00,00,00,00,C0,A8,00,0A,FF,FF,FF,00,C0,A8,00,01,
00,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00 <dev>
4.5.2 Configuring OOBM Static IP Address Using cURL
This procedure provides instructions for assiging a static IP address to the OOBM network interface using
a cURL command.
Note: This procedure uses angle brackets "
modified for your specific needs.
Step 1 : Issue a PATCH request to the applicable I/O module resource, using the data option to set the
AddressOrigin
curl
-X PATCH
-sku <username>:<password>
https://<oobm_ip>/redfish/v1/Systems/Self/EthernetInterfaces/IOModule<A/B>FRU
= 0.0.0.0
Gateway>,00,00,00,<IOM B
Netmask>,<IOM B Gateway>
= 03 (IOMA & IOMB)
= 00 (static) or 01 (DHCP)
= The IP address in four pairs of two-digit hex codes
= The netmask, in four pairs of two-digit hex codes
= The gateway, in four pairs of two-digit hex codes
= 00 (static) or 01 (DHCP)
= The IP address in four pairs of two-digit hex codes
= The netmask, in four pairs of two-digit hex codes
= The gateway, in four pairs of two-digit hex codes
215):
Note: Setting an invalid gateway will result in that field being zeroed-out.
to and provide the IP address, subnet mask, and gateway:
Static
4.5 OOBM Management Overview
Setting>,00,00,00,<IOM A
Setting>,00,00,00,<IOM B
Changing the OOBM Network Configuration
" to indicate text that should be
<example>
4. Management
IPaddr>,<IOM
217