Western Digital Ultrastar ScaleUp SE4U102 User Manual page 188

User Guide
Figure 205: Seating the 3.5in HDD Assembly
Step 45 : Repeat this action to fully install the remaining drive assemblies in the same order, from left-to-
right, rear-to-front.
Step 46 : If the chassis is being installed into a rack that will be shipped fully assembled, you must install
eight (four per side) of the included M5 x 12mm T15 Flat Head Torx screws into the two brackets
at the front of the chassis in the following locations. These screws should be tightened to
3.38-3.61 Nm / 30-32 in-lbf using a Long T15 Torx Screwdriver. If this chassis will not be installed
into a rack for shipping purposes, skip this step and move on to the next one.
Figure 206: Shipping Bracket Screw Locations (CMA Standard)
3. Support
3.9 Chassis Replacement
172