Subenclosure Nickname; Setting The Subenclosure Nickname - Western Digital Ultrastar ScaleUp SE4U102 User Manual

User Guide
serial
firmware: 2050-028
name
Step 5 : Use the WDDCS Tool's
C:\> wddcs iom
wddcs v1.1.8.0
Copyright (c) 2019-2020 Western Digital Corporation or its affiliates
Device: SCSI3:0,84,0
Dual IOM operation
IOM A
Device: SCSI3:1,29,0
Dual IOM operation
IOM B
Step 6 : Use the WDDCS Tool's
the zoning configuration of each IOM:
C:\> wddcs SCSI3:0,84,0 zone status
wddcs v1.1.8.0
Copyright (c) 2019-2020 Western Digital Corporation or its affiliates
Device: SCSI3:0,84,0
Zoning (Disabled)
C:\> wddcs SCSI3:1,29,0 zone status
wddcs v1.1.8.0
Copyright (c) 2019-2020 Western Digital Corporation or its affiliates
Device: SCSI3:1,29,0
Zoning (Disabled)
R esult: T he zone status of both IOMs should now be
4.8 Subenclosure Nickname
4.8.1 Setting the Subenclosure Nickname
This task describes instructions for viewing and setting a subenclosure's nickname using
commands.
Before you begin: In the following
either indicate a generic reference to an expected output or a command phrase that should be replaced
with the user's specific instance of that phrase (i.e.
Verify Support for the Nickname Feature
Step 1 : Verify the subenclosure's support for the nickname feature by using the
command to view the subenclosure's Supported Diagnostic Pages:
p0x0
# sg_ses <device> -p0x0
: USWSJ02819EZ0012
: Ultrastar Data102
command to determine which IOM each handle is assigned to:
iom
command along with the appropriate SEP handle to verify
zone status
examples, angle brackets surrounding a term (i.e.
sg_ses
/dev/sg2

4.8 Subenclosure Nickname

.
Disabled
).
4. Management
sg_ses
)
<device>
sg_ses <device> -
251