6. Use the key to turn the lock 180 degrees, as shown in the third panel of
7. Replace the pawl in the same orientation as before, as shown in the fourth panel
of
FIGURE 4-2
8. Hold the key in place and use the nut driver to refasten the locking nut that holds
the pawl in place, as shown in the fifth panel of
thread the nut.
Caution – Be sure to hold the key in place. Otherwise there is a risk of breaking the
small tab on the lock that serves as a stop.
9. Replace the bezel.
Note – To convert your bezel locks back so that the keys can be removed, repeat this
procedure.
4.2
Rack-Mounting the Array
To rackmount the array in a rack or a cabinet, refer to the installation manual which
is provided with the rack or refer to the Sun StorEdge 3000 Family Rack Installation
Guide for 2U Arrays on the product website.
4.3
Hardware Connections
FIGURE 4-3
an array. These procedures are designed for a redundant configuration.
4-4
Sun StorEdge 3000 Family Installation, Operation, and Service Manual • March 2004
.
identifies a typical series of hardware connections used when you install
. Be careful not to cross-
FIGURE 4-2
FIGURE 4-2