Table of Contents
Advertisement
1.2.1
Mounting the Autoloader
1. Facing the front of the rack and using the Rackmount Placement Matrix (part
number: 805-6945-xx), hold the bezel in the specified position and install and
tighten four 10-32 screws (
Note – Your rack structure might look different from the illustrations. If you have a
rack that does not have threaded screw holes, install the clipnuts in the same position,
then install the screws.
Note – Load from bottom to top and load lighter products over heavier ones, as
demonstrated in
2. Loosely thread two 10-32 screws into the back rail of the rack. These back bottom
screws should be one above the front bottom screws (
Note – To ensure a level shelf, count the holes to make sure that the screws are in
the same position on the right and left rail.
FIGURE 1-2
FIGURE 1-2
.
FIGURE 1-2
Screw Installation
).
FIGURE 1-2
Chapter 1
).
Getting Started
1-7
Advertisement
Table of Contents
Troubleshooting
