Connecting Ports - Sun Microsystems StorEdge 3000 Series Installation, Operation And Service Manual

4
C H A P T E R

Connecting Ports

This chapter provides procedures for cabling the Sun StorEdge 3310 SCSI array for
single or dual-bus configurations and for connecting the array to power and to
network devices.
The topics covered in this chapter are as follows:
"Converting Your Front Bezel Locks So the Keys Cannot Be Removed" on
I
page 4-2
"Hardware Connections" on page 4-4
I
"Connecting the Chassis to an AC Power Outlet" on page 4-5
I
"Connecting the Chassis to DC Power Outlets" on page 4-7
I
"Single and Dual Drive-Bus Configurations" on page 4-9
I
"Connecting Cables for a Single-Bus Configuration" on page 4-12
I
"Connecting Cables for a Dual-Bus Configuration" on page 4-16
I
"Connecting SCSI Ports to Host(s)" on page 4-19
I
"Cabling Configurations with Two Expansion Units" on page 4-20
I
"Configuring a COM Port to Connect to a RAID Array" on page 4-23
I
"Setting an IP Address" on page 4-24
I
"Setting Up Out-of-Band Management Over Ethernet" on page 4-25
I
Before you connect the Sun StorEdge 3310 SCSI array to the network, position the
Sun StorEdge 3310 SCSI array in the rack or in the location where it will remain.
Caution - When positioning the array, do not block the air vents at the front or back
of the unit. Follow all safety precautions specified in the Sun StorEdge 3310 Safety,
Regulatory, and Compliance Manual.
4-1