Set Password - Cisco 15216 EDFA2 Operation Manual

Set Password

Table 8-1
Attribute
MINCTMPHYST
8.9 Set Password
To restrict access to the ONS 15216 EDFA2, use the ED-PID command (see
page
ED-PID:[<tid>]:<uid>:<ctag>::<oldpid>,<newpid>;
Note that the password must be a string of up to 10 characters, where at least 2 are non-alphabetic
characters and at least 1 is a special character. See
Example 8-9
sidtidname:ONS15216 EDFA2> ED-PID::CISCO15:130::OLDPW,NEWPW;
The default user name for the administrator level is CISCO15 with no default password.
Note
Cisco ONS 15216 EDFA2 Operations Guide
8-10
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Alarm Threshold Attribute Definitions (continued)
Variable
Definition
Minimum
case
temperature
hysteresis
9-20) to change the default user password according to the following syntax:
Changing Current User's Password Using TL1
Maximum
Syntax Access
Integer Read-write Used to set the amount that the case
(0 to 10)
Example 8-9.
Chapter 8 Provisioning Using TL1
Description
temperature of the module must rise
above the minimum case temperature
alarm level before the alarm is cleared.
Set the hysteresis at a value that is
appropriate for the application so that
the alarm condition clears when the
input is stable. Consult with the Cisco
TAC to determine the correct value for
your application. As a guideline, Cisco
recommends that the hysteresis value
°
be set at 1 C. Valid entries are between
°
0 and 10 C. Setting this value to 0
disables this option.
"ED-PID" section on
78-16033-01