Lan Interface (Ethernet); Chapter 4 Provisioning Using Ash And Snmp - Cisco 15216 EDFA2 Operation Manual

Communications
Modem communication is not necessary unless dial-up remote communication is desired.
Note
3.5.4.6 PC Connection via Modem
The ONS 15216 EDFA2 and modem are connected through the RS-232 (EIA/TIA-232) port using a
DB-9 connector. The modem, PC, and ONS 15216 EDFA2 should be physically set up as displayed in
Figure
Figure 3-8
GND
Using the terminal program from the PC, enter the ATDT command with the appropriate telephone
number to call the remote ONS 15216 EDFA2 modem. After the modems synchronize, log into the
ONS 15216 EDFA2 using the correct user name and password. Refer to
Installation and Configuration," Chapter 6, "ASH Commands,"
additional information on commands.

3.5.5 LAN Interface (Ethernet)

You can connect to the ONS 15216 EDFA2 to an Ethernet LAN for remote access.
Before communicating and managing the ONS 15216 EDFA2 via the Ethernet port, the user must first
Note
enter an IP address. To set an IP address, see
Chapter 8, "Provisioning Using TL1."
Telnet is an application that allows remote management using IP over the Ethernet LAN. The following
types of commands can be issued through a Telnet session:
•
•
•
Cisco ONS 15216 EDFA2 Operations Guide
3-14
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
3-8. Use Figure 3-8 to properly connect the ONS 15216 EDFA2 to the modem.
DB-9 Pinout for RS-232 (EIA/TIA-232) Port
RXD TXD
5 4 3 2 1
9 8 7 6
RTS CTS
SNMP MIB commands (Chapter 5, "SNMP MIB Installation and
ASH CLI commands (Chapter 6, "ASH
TL1 commands (Chapter 9, "TL1
and
Chapter 4, "Provisioning Using ASH and SNMP"
Commands")
Commands")
Chapter 3 Installation
Chapter 5, "SNMP MIB
Chapter 9, "TL1 Commands,"
Configuration")
78-16033-01
for
or