Table 9-25 Rept Alm Dwdm Syntax Description - Cisco 15216 EDFA2 Operation Manual

TL1 Commands and Autonomous Messages
F I N A L D R A F T - C I S C O C O N F I D E N T I A L

Table 9-25 REPT ALM DWDM Syntax Description

Parameter
time
almcde
atag
aid
conddescr
condtype
date
ntfncde
ocrdat
ocrtm
sid
srveff
Cisco ONS 15216 EDFA2 Operations Guide
9-26
Syntax Description
hh:mm:ss Time of origination of TL1 message.
The alarm severity code for the TL1 message. Possible values
are:
*C Critical alarm.
** Major alarm.
* Minor alarm.
A No alarm. Occurs only when ntfncde is NA.
0 - 999 An integer between 0 and 999 used as a sequence number in
autonomous messages.
Always 1.
1 Directly affecting the optical signal.
Detailed text description of the event. The conddescr is 1 to 64
characters of ASCII text. See condtype below.
Condition type identifies the type of alarm (maps to
cerent15216EdfaLogEventID). Possible condtype and
corresponding conddescr (in quotes) are:
LOS "Loss of Signal" (input power) alarm
(cerent15216EdfaAlarmLpin).
GAIN "Gain Out of Range" alarm (cerent15216EdfaAlarmGain).
LPOUT "Loss of Output Power" alarm (cerent15216EdfaAlarmLpout).
yyyy-mm-dd Date of origination of TL1 message.
Notification code (maps to cerent15216EdfaAlarmPriority).
Possible values are:
CR Critical alarm.
MJ Major alarm.
MN Minor alarm.
CL Cleared alarm.
NA No alarm.
m-d Date (month-day) of the event occurrence (derived from
cerent15216EdfaDateAndTimeString).
h-m-s Time (hour-minute-second) of the event occurrence (derived
from cerent15216EdfaDateAndTimeString).
string Source identifier uniquely identifies the source of a TL1
autonomous command.
Effect on service. Possible values are:
SA Service affecting.
NSA Non-service affecting.
Chapter 9 TL1 Commands
78-16033-01