Rtrv-Alm-All; Table 9-29 Rept Evt Fxfr Syntax Description - Cisco 15216 EDFA2 Operation Manual

Chapter 9 TL1 Commands
Example 9-24 REPT EVT FXFR Message
Amp01 2001-06-18 14:48:44
A 141 REPT EVT FXFR
"EQPT:VMRLS20.EXE,COMPLD,SUCCESS,8051"
;

Table 9-29 REPT EVT FXFR Syntax Description

Parameter
atag
aid
bytes_xfrd
filename
fxfr_rslt
fxfr_status
date
sid
time

9.7.23 RTRV-ALM-ALL

Command RTRV-ALM-ALL
Generates a report on all active alarms (except environmental (ENV) alarms as per Telcordia
GR-833-CORE). Note that the ccm does not appear in the response for EQPT alarms.
Note The messages for Loss of Signal (LOS), Gain Out of Range (GAIN), and Loss of Output Power
(LPOUT) are prioritized (in the order just listed) so that only one message can be delivered at one time.
For example, if the ONS 15216 EDFA2 detects both a loss of input signal and a loss of output power at
the same time, it will deliver only the Loss of Signal (LOS) message to the user. This prioritized filtering
of alarms does not occur with the SNMP delivery of alarms of the ONS 15216 EDFA2.
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Syntax
0 - 999
EQPT
SUCCESS
FAILURE
START
COMPLD
yyyy-mm-dd
string
hh:mm:ss
Description
An integer between 0 and 999 used as a sequence number in
autonomous messages.
Always EQPT.
General parameters of the ONS 15216 EDFA2 (not directly
affecting optical signal or power bus).
Total number of bytes transferred when fxfr_status is
COMPLD. See fxfr_status below.
Identifies the name of the file that is being transferred.
File transfer result indicates success or failure of the file
transfer. This is displayed only when the file transfer has
completed (i.e., fxfr_status is COMPLD). Possible values are:
File transfer was successful.
File transfer failed.
File transfer status of ONS 15216 EDFA2's file transfer at the
current time. (The option IP (in progress) has not been
implemented.) Possible values are:
File transfer has started.
File transfer has completed.
Date of origination of TL1 message.
Source identifier uniquely identifies the source of a TL1
autonomous command.
Time of origination of TL1 message.
Cisco ONS 15216 EDFA2 Operations Guide
TL1 Commands and Autonomous Messages
9-33