Power Bus - Cisco 15216 EDFA2 Operation Manual

Chapter 5 SNMP MIB Installation and Configuration
5.6.4.3.2 CtmpMinHysteresis
Command snmp attribute get local cerent15216EdfaCtmpMinHysteresis
Syntax Description
snmp attribute get local cerent15216EdfaCtmpMinHysteresis
Displays the minimum case hysteresis temperature alarm threshold.
The following command displays case temperature alarm hysteresis and other data:
•
The cerent15216EdfaCfgGroup command is shown in
about all of the parameters in the cerent15216EdfaCfgGroup table, see

5.6.5 Power Bus

5.6.5.1 Power Bus Mode
Command
snmp attribute get local cerent15216EdfaPowerBusMode
Syntax Description
snmp attribute get local cerent15216EdfaPowerBusMode
Displays the power bus mode (simplex or duplex).
The following command displays power bus voltage and other data:
•
5.6.5.2 Power Bus Alarm Threshold
5.6.5.2.1 PowerBusDCVoltageMax
Command snmp attribute get local cerent15216EdfaPowerBusDCVoltageMax
Syntax Description snmp attribute get local cerent15216EdfaPowerBusDCVoltageMax
Displays the maximum allowable power bus DC voltage (multiplied by –10V).
The following command displays power bus voltage and other data:
•
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
snmp row display local cerent15216EdfaCfgGroup command
snmp row display local cerent15216EdfaCfgGroup command
snmp row display local cerent15216EdfaCfgGroup command
Example 5-14 on page 5-28. For information
Table 5-6 on page
Cisco ONS 15216 EDFA2 Operations Guide
Retrieving Information
5-12.
5-29