Input Power (Signal) - Cisco 15216 EDFA2 Operation Manual

Retrieving Information
5.6.5.2.2 PowerBusDCVoltageMin
Command snmp attribute get local cerent15216EdfaPowerBusDCVoltageMin
Syntax Description
snmp attribute get local cerent15216EdfaPowerBusDCVoltageMin
Displays the minimum allowable power bus DC voltage (multiplied by –10V).
The following command displays power bus voltage and other data:
•

5.6.6 Input Power (Signal)

5.6.6.1 Input Power (Signal) Value
5.6.6.1.1 InPowerduW
Command snmp attribute get local cerent15216EdfaInPoweruW
Syntax Description
snmp attribute get local cerent15216EdfaInPoweruW
Displays input power value in microwatts.
The following command displays the ONS 15216 EDFA2 input power value and other status
information:
•
For information about all of the parameters in the cerent15216EdfaOverallStatusGroup table, see
Table 5-8 on page
5.6.6.1.2 InPowerdBm
Command snmp attribute get local cerent15216EdfaInPowerdBm
Syntax Description snmp attribute get local cerent15216EdfaInPowerdBm
Displays the input power value in dBm. The dBm units are converted from µW to dBm, so theses values
could be slightly different due to rounding error.
The following command displays input power value and other status information:
•
For information about all of the parameters in the cerent15216EdfaOverallStatusGroup table, refer to
Table 5-8 on page
Cisco ONS 15216 EDFA2 Operations Guide
5-30
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
snmp row display local cerent15216EdfaCfgGroup command
snmp row display local cerent15216EdfaOverallStatusGroup command
5-17.
snmp row display local cerent15216EdfaOverallStatusGroup command
5-17.
Chapter 5 SNMP MIB Installation and Configuration
78-16033-01