Table of Contents
Advertisement
1.1
Explanation of servo parameters
For how to interpret the servo parameter numbers, refer to "Interpreting servo parameter numbers" in User's Manual
(Introduction).
The following explains how to read the details of servo parameters.
Item
Explanation
No.
Indicates the servo parameter No., which
can be identified by the servo parameter
group and number.
Symbol
Indicates the abbreviation of the servo
parameter.
"*" added to abbreviations means the
following.
*: After setting, cycle the power, or reset
either the controller or the software.
**: After setting, cycle the power or reset
the software.
Name
Indicates the name of the servo parameter.
Initial value
Indicates the servo parameter initial value at factory setting.
(unit)
When there is a unit in the servo parameter, the unit is shown with [ ].
Setting range
Indicates the setting range of the servo parameter.
Setting method
For multi axis servo amplifiers, "Common" means that the same setting is applied to each axis. "Each axis" means that the setting for each
axis is different.
The latest setting value for "Common" is applied to all axes.
Ver.
Indicates the supported firmware version of the servo amplifier. The servo parameter is available on servo amplifiers with the firmware
version or later.
Servo parameter No., symbols, and names are indicated as follows.
[Pr. PA01 Operation mode (**STY)]
Symbol
Name
No./Detail No.
1 SERVO PARAMETER DETAILS
1.1 Explanation of servo parameters
1
11
Advertisement
Table of Contents
