Husqvarna FE 250 EU 2014 Repair Manual page 169

ENGINE
18
If there is damage or wear:
-
Change the spring retainer.
8
-
Check pretension ring
If there is damage or wear:
-
Change the pretension ring.
0
-
Check spring washer
If there is damage or wear:
-
Change the spring washer.
-
Check the thrust face of pressure cap
If there is damage or wear:
-
Change the pressure cap.
-
Check clutch center @ for damage and wear.
If there is damage or wear:
-
Change the clutch center.
-
Check damping rubber pieces
If there is damage or wear:
-
Change the damping rubber pieces.
-
Check the inner clutch hub Q) for damage and wear.
If there is damage or wear:
-
Change the inner clutch hub.
-
Check the thrust surfaces of the clutch facing discs in clutch basket
If there is damage or wear:
-
Change the clutch facing disks and the clutch basket.
48
-
Check needle bearing
If there is damage or wear:
-
Change the needle bearing and collar sleeve.
-
Check the intermediate clutch disks
If the intermediate clutch disks are not even or exhibit pitting:
-
Change all intermediate clutch disks.
-
Check clutch facing discs
If there is discoloration or scoring:
-
Change all clutch facing disks.
-
Check the thickness of clutch facing discs
I
Clutch facing discs - thickness of total package
If the clutch facing disk does not meet specifications:
-
Change all clutch facing disks.
for damage and wear.
for damage and wear.
(D
for damage and wear.
C,
for damage and wear.
«8
and collar sleeve for damage and wear.
41)
for damage and wear.
4D
for discoloration and scoring.
4D.
4D
for damage and wear.
I ;:,: 26.4 mm (;:>: 1.039 in)
167