Husqvarna FE 250 EU 2014 Repair Manual page 30

6
FORK, TRIPLE CLAMP
-
Lubricate and mount dust boot
I
Lubricant (T511)
Info
Always change the dust boot, seal ring, lock ring and support ring.
Mount the sealing lip with the spring expander facing downward.
-
Slide on lock ring(!}.
-
Lubricate and slide on seal ring (5).
I
Lubricant (T511)
Info
Mount with the sealing lip facing down and the open side facing up.
-
Slide on support ring
-
Remove the special tool.
-
Grind the edges of the sliding bushings with sandpaper grit 600, clean the bush-
ings and lubricate them.
I
Fork oil (SAE 4) (48601166S1)
201715-10
-
Slide on the lower sliding bushing
-
Mount the upper sliding bushing (D.
Info
Do not use a tool; pull the ends apart slightly by hand.
-
Warm the outer tube in area
Guideline
so c
1 (122 °F)
0
-
Slide the outer tube onto the inner tube.
-
Hold the lower sliding bushing with the longer section of the special tool.
I
Mounting tool (T14040S)
-
Push the sliding bushing all the way into the outer tube.
-
Position the support ring.
-
Hold the seal ring with the shorter section of the special tool.
I
Mounting tool (T14040S)
-
Push the seal ring and support ring all the way into the outer tube.
O.
(� p. 264)
(� p. 264)
8.
(� p. 262)
0-
f)
of the lower sliding bushing.
(� p. 276)
(� p. 276)
28