Removing The Valves - Husqvarna FE 250 EU 2014 Repair Manual

ENGINE
18
18.4.21

Removing the valves

••
-
l:o/
:EV1
•
Remove screw plugs
Screw appropriate screw
Hold cam levers
• Info
I
If the cam levers will continue to be used, note down their installation posi­
tion.
Take the shims from the valve spring retainers and put them aside corresponding
to their installation position.
306764-10
Pre-tension the valve spring using the special tool.
Valve spring mounter (59029019000)
Insert for valve spring lever (77229060000)
Remove the valve keys and unload the valve spring.
306765-10
Remove the valve spring retainer and valve springs.
Mark the valve spring according to its normal built-in position.
Pull the valve down out of the valve guide.
Remove valve stem seal
I
Pliers for valve stem seals (77229010000)
Remove valve spring seat
Mark the valves corresponding to their installation position.
Info
I
Place the valves in a carton corresponding to their installation position and
label them .
300117-10
O
with the O-ring.
8
into the cam lever shaft.
8
and remove the cam lever shaft.
(� p. 269)
(�
8
with the special tool.
(�
0-
p. 273)
p. 272)
159