Husqvarna FE 250 EU 2014 Repair Manual page 86

12
FUEL TANK, SEAT, TRIM
A
Warning
Danger of poisoning
-
Avoid skin, eye and clothing contact with fuel.
-
Immediately consult a doctor if you swallow fuel.
-
Do not inhale fuel vapors.
-
In case of skin contact, rinse the affected area with plenty of water.
-
Rinse the eyes thoroughly with water, and consult a doctor in case of fuel contact with the eyes.
-
Change your clothing in case of fuel spills on them.
-
Keep fuels correctly in a suitable canister, and out of the reach of children.
Fuel is poisonous and a health hazard.
Condition
The fuel tank is full.
Ensure that the battery voltage does not drop below 12.5 V.
The diagnostics tool is disconnected.
-
Thoroughly clean the plug-in connection of the fuel line using compressed air.
• Info
I
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve.
-
Press on the small metal plate and disconnect fuel hose connection
Info
•
I
Remaining fuel may flow out of the fuel hose.
-
Mount special tool
I
Pressure tester (61029094000)
-
Mount special tool
I
Testing hose (61029093000)
-
Position the hose end in a fuel cannister.
Guideline
I
Minimum size of fuel cannister
-
Connect the diagnostics tool and start it.
-
Select the
Guideline
I
Maximum duration of the actuator test
-
Check the fuel pressure with the filler cap closed.
Fuel pressure
When the fuel pump is active
If the specification is not reached:
-
Open the filler cap.
-
Check the tank air vent system.
-
Check the fuel pressure with the filler cap open.
Fuel pressure
When the fuel pump is active
If the specification is not reached:
-
Check that the fuel line is clear.
-
Change the fuel filter.
-
Change the fuel pump.
-
Stop the
"Function test of fuel pump control"
/400928-01
button.
"Quit"
8.
(� p. 270)
(D
with nozzle label 0,60.
(� p. 270)
"Function test of fuel pump control"
(l!!ll p. 75)
(� p. 80)
(� p. 82)
O.
110 I (2.6 US gal)
actuator test.
I
3 min
3.35 ... 3.65 bar (48.6 ... 52.9 psi)
3.35 ... 3.65 bar (48.6 ... 52.9 psi)
actuator test by pressing the
84