ENGINE
18
18.4.7
Installing the crankshaft bearing inner race
18.4.8
Changing the connecting rod, conrod bearing, and crank pin
-
Take off the compensating disk.
-
Repeat the operation on the opposite side.
Main work
-
Fix the crankshaft in the vise.
•
Info
I
Use soft jaws.
-
Slide on compensating disk
•
Info
I
The compensating disks have a larger diameter than the crankshaft stub.
306538-10
Ensure that the compensating disks are centered and fixed with a small
amount of grease.
Add compensating disks equally on both sides.
-
Heat the crankshaft bearing inner race in special tool
Guideline
1120 °C (248 °F)
I
Tool for inner bearing race (58429037037)
-
Repeat the operation on the opposite side.
-
Ensure that the new crankshaft bearing inner race is flush.
Info
•
I
After replacing the crankshaft bearings, the crankshaft end play must be
measured.
Finishing work
-
Measure the crankshaft end play.
Main work
-
Position crankshaft
1 Separator plate (77029009001)
-
Push the crank pin out of the upper crankweb using the special tool.
I
Pressing tool for crankshaft, complete (75029047000)
•
Info
I
Hold the lower crank web.
-
Remove the connecting rod.
-
Press the crank pin out of the lower crank web.
O.
(il!ll
p. 268)
(il!ll
p. 154)
O
in the press using special tool
(il!ll
p. 271)
152
8
and mount together.
8-
(a
p. 271)