Husqvarna FE 250 EU 2014 Repair Manual page 99

WHEELS
14
l
o o o--�--0 o
2 3
16 17 18
-
Pull on the upper part of the chain with the specified weight 6).
Guideline
I
Weight of chain wear measurement
-
Measure the distance G) of 18 chain links in the lower chain section.
Info
•
I
Chain wear is not always even, so you should repeat this measurement at
different chain positions.
Maximum distance G) at the longest
chain section
If the distance G) is greater than the specified measurement:
-
Change the drivetrain kit.
l
•
I
o
400987-10
-
Check the chain sliding guard for wear.
If the bottom edge of the chain bolt is in line with or below the chain sliding
guard:
-
Change the chain sliding guard.
-
Check that the chain sliding guard is firmly seated.
If the chain sliding guard is loose:
-
Tighten the chain sliding guard.
Guideline
Screw, chain sliding
guard
-
Check the chain sliding piece for wear.
If the bottom edge of the chain bolt is in line with or below the chain sliding
piece:
-
Change the chain sliding piece.
-
Check that the chain sliding piece is firmly seated.
If the chain sliding piece is loose:
-
Tighten the chain sliding piece.
Guideline
Screw, chain sliding piece
110 ... 15 kg (22 ... 33 lb.)
(� p. 99)
Info
When the chain is replaced, the rear sprocket and engine sprocket
should also be changed.
New chains wear out faster on old, worn sprockets.
M6
272 mm (1 0. 71 in)
6Nm Loctite
(4.4 lbf ft)
M8 15 Nm
(11 .1 lbf ft)
97
243
® ™