Table of Contents
Advertisement
BEFORE YOU START
CARTON CONTENTS / ITEM CHECKLIST
•
The Engine, Fascia and Flue Adapter for the Rinnai 650FS Gas Fire is supplied in one carton.
•
The Flue is available as a kit, 650FSKIT01 and is supplied separately.
•
Burn Media; Logs R2423 or Stones R2422 are supplied separately.
Ensure that the components listed below are present in the carton before proceeding with the installation.
Major component descriptions and carton contents
Rinnai 650 Engine (inside Cabinet)
Co-axial Flue Adapter (pre-fitted to the heater engine).
Four sided 650 Fascia - Black
Free Standing Cabinet.
Operation and Installation manual.
-
Various labels
3
Burn media supplied
separately
ADDITIONAL TOOLS REQUIRED ( NOT SUPPLIED )
•
7mm AF Spanner (for fascia top attaching screws)
•
No. 2 Phillips (unless specified otherwise, all screws are No. 2 Phillips)
CLEARANCE CONSIDERATIONS
Refer to "Clearances" on page 7 for detailed clearance allowances. A minimum of 50mm clearance is required
for all surfaces of the cabinet to allow for adequate ventilation. Consideration must be given for gas and electrical
connections located at the lower rear of the cabinet.
SELECTING A POSITION
Please consider the following when deciding on a position for the heater:
•
This 650 Freestanding appliance is suitable only for indoor installation.
•
It is not intended as an outdoor appliance.
•
It is not intended as a built-in appliance.
•
Gas and electrical connections are at the rear. It is essential therefore to allow adequate room at the back of the
appliance for access to the gas and electrical inlets and the pedestal cover plate for these connections.
•
This appliance is suitable for a corner installation.
FLUEING REQUIREMENTS
No Flue bends are authorised with this heater.
IMPORTANT
•
Consider the location of the vertical flue when choosing a position for your heater.
•
Use in conjunction with flue kit FS650KIT01.
•
Only use a vertical flue with a maximum length of 7.5 metres with zero bends. The heater will not function with
a horizontal flue. No bends are permitted with this heater.
Rinnai
2
6
Qty
1
1
1
1
1
n/a
4
5
650FS FIM
Advertisement
Table of Contents
