Rinnai 650FS Installation Manual page 11

Step 6. Gas and electrical connection.
Cabinet access points.
Gas and electrical connections enter the cabinet at the bottom rear. Allowances have been designed into the
cabinet to accommodate; left, right, centre A, through the pedestal (for under floor)  and through the base panel
 (for on top of floor). Rubber grommets have been supplied to protect cables and pipes. Refer to the engine
installation manual for full gas and electrical connection details.
The grommet for the electrical cable will need to be slit to enable the 3 pin plug to be accommodated.
NOTE
A
Step 7. Return engine to cabinet.
1. Return engine and secure into position in reverse order of "Step 5. Remove Engine" on page 10.
When returning the engine to the cabinet, ensure that the electrical and gas lines are not
pinched, squashed, bunched or otherwise damaged. Refer to adjacent image.
IMPORTANT
2. Refit top panel in reverse order of "Step 4. Remove top panel" on page 10.
DO NOT re-attach fascia at this point. Proceed to installing the flue.
3.
Rinnai
B
11
CABINET INSTALLATION
C
650FS FIM