Set The Power-On State (Poweron) - ITech IT-M3900B Series User Manual

4. After the parameter settings are complete, press [Enter].

6.6 Set the Power-on State (PowerOn)

This menu item is used to control the settings and output state when the power
system is powered on.
The detailed power-on parameters and output state are as follows.
•
•
•
•
The procedures to set the menu item are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
2. Turn the knob to select the PowerOn and press [Enter].
3. Press the Left / Right key or turn the knob to adjust the value of this
•
On: Default value, indicates the beeper is on.
•
Off: Indicates the beeper is off.
At this point, the beeper status takes effect immediately.
The voltage, current, power, resistance setting values displayed on the main
interface when the instrument is powered on.
Only in the Load mode, the resistance setting value will be displayed.
And, whether the instrument works in Source or Load mode.
Parameter setting values in the Config menu.
The output state of the power system, i.e., the [On/Off] key state.
ter the system menu.
parameter.
•
Reset: Default value, indicates when the instrument is powered on, the
instrument will initialize some parameter settings or state.
The affected parameters and the reset information are as shown in the
following table.
Copyright © Itech Electronic Co., Ltd.
Basic Operation
154