Transport; Loading The Vehicle For Transport; Towing The Vehicle - Kärcher MC 130 Manual

8.4.3 Removing the front power lift from the
vehicle
Raise the front power lift up to its end position.

Loosen the hydraulic hose.

Unlock the front power lift (top lever position).

1 Holder for support front power lift
2 Frame front power lift
Move the changing carriage under the front power lift

using a pallet truck.
Ensure that the holder for the support of the front power

lift is positioned in the frame of the front power lift upon
raising the pallet truck.
Move out the front power lift using a pallet truck.

Put the front power lift down in a protected place and

move out the pallet truck.
9

Transport

9.1

Loading the vehicle for transport

DANGER
Risk of damage!

The vehicle is not approved for crane loading.

Do not use a fork lift, the vehicle could get damaged.
WARNING
Risk of personal injury or damage!

Observe the weight of the vehicle when loading it!
Unladen weight (without attachment
sets)
MC 130
MC 130 advanced
* If attachments are installed, the weight is accordingly
higher.
Slowly drive the vehicle onto the transport vehicle.

Note
If the vehicle is not in running condition, observe Chapter
"Towing".
84
9.1.1
1 Storage transport restraint
2 Bolt with safety clip
3 Transport lock
Pull out both bolts.

Push the transport restraint out of the storage location.

Secure the transport restraint by means of bolts.

9.1.2
WARNING
Risk of accident!
2275 kg*

The vehicle must be secured against shifting during
1736 kg*
transport.
Park the vehicle.

Secure the vehicle on the fixing eyelets on the left and

the right using tie down straps.
9.2
WARNING
Risk of accident, risk of injury!

Securely attach the towing eye with safety bolts and
safety bracket.
CAUTION
Risk of damage!

The vehicle must not be towed faster than at walking
speed.

Only slowly push or pull the vehicle.
To tow the vehicle, the spring load of the parking brake

must be released.
See chapter "Hydraulic valve emergency control | Re-
leasing the spring load of the parking brake"
In addition, open the bypass valves.

The vehicle is towed using the towing eye at the front.

The towing eye is not an integral part of the frame, but
rather must be attached as required. See chapter "At-
taching the towing eye to the frame".
32
-
EN
Fastening of the transport restraint on the
articulated joint
Securing the vehicle

Towing the vehicle