Kärcher MC 130 Manual page 93

11.4.14 Clean and replace the air filter (MC 130
advanced plus)
1 Wing bolt
2 Air filter housing
3 Locking
Remove the right side motor panel.

Open the wing screw approx. two turns.

Swivel the entire air filter unit outwards as far as possi-

ble.
Screw the wing screw in tightly.

Open the locks (3x) on the air filter housing.

Remove the air filter housing.

1 Air filter housing
2 Filter cartridge
3 Safety cartridge
Remove the filter cartridge and the safety cartridge.

Clean the interior of the air filter reservoir.

Clean the filter insert: Knock the dust off on a hard sur-

face, do not blow out with compressed air.
Replace the safety cartridge by a new one, do not clean

it.
Check that the sealing surface and the filter insert are

clean and undamaged.
Insert the cleaned filter insert.

Important: A severely contaminated or damaged filter
insert must be replaced.
Once the air filter unit is assembled, pivot it back in

again and tighten with the wing screw.
11.4.15 Replacing the dust filter of the cabin
The fresh air is drawn in through a dust filter or a fine dust
filter (filter class F8 optionally available) at the side of the
B-pillar of the driver cabin.
In case of frequent work in dusty environments, replace
more often.
11.4.15.1 Replacing the dust filter on the outer cabin
1 Cover
2 Dust filter
Unscrew 6 screws of the cover and remove the cover

with the dust filter.
Replace the dust filter in the cover by a new one.

Reattach the cover with the new dust filter.

11.4.15.2 Replacing the dust filter on the inside of the
cabin
1 Driver seat
2 Dust filter
3 Passenger seat
Push both seats towards the front.

Take out the dust filter.

Check/clean dust filter, replace if necessary.

Installation information
Pay attention to the correct fitting position during reinstal-
lation.
41
-
EN 93