8
Troubleshooting
Problem
No or limited motion The cable is not
Reduced accuracy
P-73x Nanopositioners
Possible Causes
connected correctly
Excessive load
The load was
changed
Warping of the base
body or the moving
platform
PZ103E
8 Troubleshooting
Solution
Check the cable connections.
Do not exceed the permissible
compressive/tensile stress capacity
according to the specifications
(p. 37).
After changing the load to be moved,
perform a zero-point adjustment
(see controller manual).
Only mount the P-73x on surfaces
with the following characteristics:
−
Evenness of at least 20 μm
−
The thermal expansion
properties are similar to those of
the P-73x (e. g. surfaces made
of aluminum).
Only affix loads with the following
characteristics on the P-73x:
−
The contact surface of the load
with the moving platform of the
stage has an evenness of at
least 20 μm.
−
The thermal expansion
properties are similar to those of
the P-73x (e. g. loads made of
aluminum).
Version: 1.0.0
33