Table of Contents
Advertisement
OPTIONS FOR VENTILATION
This hood can be set up for either external venting or recirculation of the air.
The type of setup should be decided before commencing installation.
EXTERNAL VENTING
If you have an outlet to the outside, your cooker
hood can be connected as shown in the
diagram using the flexible exhaust pipe
(supplied). Alternatively, any suitable extraction
duct (enamel, aluminium, flexible pipe or
inflammable material with an interior diameter of
150mm) can be used.
An adaptor is also supplied to enable you to
connect your hood to pre-existing 120mm
diameter ducting.
If this is the chosen installation method
consideration to the route of the vent pipe
should be made prior to installation.
RECIRCULATION
This Cooker hood also supports the recirculation of
air once it has passed through the filters. The
filtered air is then expelled through the vent holes in
the side of the chimney.
When setting the unit up in this configuration,
carbon filters should also be used to remove odors
from the air. Details of sourcing and fitting the filters
can be found in the Carbon filter section.
When setting up for recirculation the installation instructions should be
followed, but the vent pipe should not be attached, allowing the air to be
expelled through the vents on the side of the chimney.
6
Advertisement
Table of Contents
