Pci - HP xw4400 Service And Technical Reference Manual

5. Close the PCI retention clamp 4 by rotating the clamp downward and pushing on the two green
snaps down from the rear panel of the chassis.
Figure 4-24

PCI

To remove a PCI card:
1. Disconnect power from the system
access panel
on page
2. Lift the PCI levers 1 by first pressing down and then up.
3. Lift the PCI card 2 out of the chassis. Store the card in an anti-static bag.
4. Install a PCI slot cover and close the PCI levers. If the PCI levers do not close, be sure all cards
are properly seated and then try again.
Figure 4-25
80 Chapter 4 Removal and replacement procedures
Installing the PCI card
(Side access panel on page
77), if installed.
Removing the PCI card
(Predisassembly procedures on page
66), and remove the PCI retainer
60), remove the side
(PCI retainer
ENWW