3.
Lift up on the green drive-lock release tab 1 and slide the hard drive 2 out of the chassis.
Figure 4-48
To install one or two SATA hard drives:
1.
Disconnect power from the system
access panel
2.
Select a drive bay in which to install the drive.
3.
Push the drive into the selected bay until it snaps into place.
4.
Attach the data 1 and power 2 cables to the drive.
Figure 4-49
ENWW
Removing the hard drive
(Predisassembly procedures on page
(Side access panel on page
Installing the SATA hard drive
66).
Steps for removal and replacement of components
60) and remove the side
95