HP xw4400 Service And Technical Reference Manual page 39

Table 3-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading Option
Ignore Changes
and Exit
Save Changes
and Exit
Storage Device
Configuration
Storage Options
ENWW
Description
Exits Computer Setup without applying or saving any changes.
Saves changes to system configuration and exits Computer Setup.
Lists all installed non-SCSI storage devices and provides options for getting specific information
about each device.
NOTE SCSI storage drives will not be listed in Computer Setup (F10).
Hard Disk
Provides information about the hard disk drives in the system.
CD-ROM
Provides information about the CD-ROM drives in the system.
Diskette Type (for legacy diskette drives only) Identifies the highest capacity media type accepted
by the diskette drive. Options are 3.5" 1.44 MB, 5.25" 1.2 MB, and Not Installed.
Default Values
Multisector Transfers Options are 8, 16, and Disable.
Transfer Mode Specifies the active data transfer mode. Options (subject to device capabilities) are
Max UDMA, PIO0, Max PIO, Enhanced DMA, and Ultra DMA0
A new Automatic option has been added to allow for BIOS to automatically determine the
translation mode used to configure a previously formatted SATA or USB mass storage device. This
prevents you from having to know how the mass storage device was previously formatted.
Ordinarily, the translation mode selected automatically by the BIOS should not be changed. If the
selected translation mode is not compatible with the translation mode that was active when the
disk was partitioned and formatted, the data on the disk will be inaccessible.
Translation Mode Options are Automatic, Bit Shift, LBA Assisted, Use (Cylinders, Heads, Sectors),
and Off.
Removable Media Boot
Enables/disables ability to boot the system from removable media.
Legacy Diskette Write
Enables/disables ability to write data to removable media.
BIOS DMA Transfers
Enable/disables the BIOS use of DMA for transfers.
SATA Emulation
Options are Separate IDE Controller, Combined IDE Controller, and RAID+AHCI
NOTE DriveLock is not available in RAID+AHCI mode.
IDE Controller
Enables/disables primary IDE controller.
Primary SATA Controller
Computer Setup (F10) Utility 29