System Board - HP xw4400 Service And Technical Reference Manual

Hp xw4400: reference guide
Hide thumbs Also See for xw4400:
Table of Contents

Advertisement

3.
Align the triangle on the top of the processor with the triangle on the corner of the processor socket
and install the processor into the socket. Ensure that the underside of the processor is level with
the top of the processor socket. Lightly press down on the top of the processor while closing the
socket lever.
Figure 4-57
4.
Check for proper processor seating in the socket by carefully trying to lift the processor out of the
socket with your fingers. A properly seated processor does not lift out of the socket.

System board

To remove the system board:
1.
Disconnect power from the system
access panel
the CPU heatsink
2.
Disconnect all cabling from the system board.
NOTE
board. Refer to
3.
Press the release tab 1 as shown in the following illustration.
102
Chapter 4 Removal and replacement procedures
Seating the processor
(Predisassembly procedures on page
(Side access panel on page
(CPU heatsink on page
Make note of the cable connections before disconnecting them from the system
Power connections to drives on page 84
66), remove all expansion boards, graphics cards, and
98)
for more information.
60) and remove the side
ENWW

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents