Sata Hard Drive - HP xw4400 Service And Technical Reference Manual

7. Connect the hard drive LED cable from the card to the hard drive LED connector on the system
board. You can find the location of this connector on the illustration on the inside of the side access
panel.
Figure 4-46

SATA hard drive

For more information on SATA hard drives and the SATA RAID configurations, refer to the SATA devices
appendix.
To remove a hard drive:
1. Disconnect power from the system
access panel
2. Disconnect the data 1 and power 2 cables from the hard drive.
Figure 4-47
94 Chapter 4 Removal and replacement procedures
Connecting the SAS cable to the hard drive
(Predisassembly procedures on page
(Side access panel on page
Removing the hard drive
66).
60) and remove the side
ENWW