HP xw4400 Service And Technical Reference Manual page 99

3. Press down on the yellow drive-lock release lever 1 and gently slide the drive 2 out of the chassis.
Figure 4-37
4. After pulling the drive 1 out, remove the four guide screws 2 from the drive. Only remove the four
guide screws if you plan to install another drive.
Figure 4-38
To install an optical drive:
1. Disconnect power from the system
access panel
on page
2. Insert the four guide screws 1 into the drive.
3. Align the screws with the grooves in the drive bay and gently slide 2 the drive into the unit until it
snaps into place.
CAUTION
easily disengaged. Failure to do so can cause damage to the drive when moving the
workstation.
ENWW
Removing the optical drive from the chassis
Removing the optical drive screws
(Side access panel on page
67).
Ensure that the optical drive is secure by pulling to see if the drive can become
(Predisassembly procedures on page
66) and remove the front bezel
Steps for removal and replacement of components
60), remove the side
(Front Bezel
89