Seagull Models YAK 11 Assembly Manual page 27

2.
3.
Slide the vertical stabilizer into the slot
in the top of the fuselage. he rear edge of
the stabilizer should be lsh with the rear
edge of the fuselage and the lower rudder
hinge should engage the precut hinge slot
in the lower fuselage. he bottom edge of
the stabilizer should also be imly pushed
against the top of the horizontal stabilizer.
4.
While holding the vertical stabilizer im-
ly in place, use a pen and draw a line on
eachside of the vertical stabilizer where it
meets the top of the fuselage.
5.
6.
Horizontal 90º
Stabilizer.
Slide the vertical stabilizer back inplace.
Using a triangle, check to ensure that the
vertical stabilizer is aligned 90º to the
horizontal stabilizer.
7.
Epoxy
Vertical
Stabilizer.
27