Seagull Models YAK 11 Assembly Manual page 6

RENO AIR CARE YAK-11 "PERESTROIKA"
4.
Remove the control horns from the
control surfaces. Apply epoxy to the slot
in the aileron and lap. Make sure the
epoxy gets into the slot for a good bond
between the surfaces and control horn.
5.
Apply epoxy to the area of the control
horns that ist into the slots. Use enough
epoxy so the control horns will be fully
bonded to the ied surfaces.
6.
6
Epoxy
Epoxy
Instruction Manual.
Before the epoxy fully cures, remove
the tape from around the control horn.
his will allow the epoxy to low around
the control horn, creating a small ilet
between the control horn and surface for
a iished look and secure bond.
7.
INSTALL FLAP CONTROL HORN
Install the lap control horn using the
same method as same as the aileron con-
trol horns.
1.
Fiberglass control horn
2.