Installing A Hard Disk Drive In Position 1 (Rear Position) - HP Visualize b132L Owner's Manual

B_configure.doc 129 Thu Jul 11 10:48:31 1996
Figure 38

Installing a Hard Disk Drive in Position 1 (Rear Position)

Perform the following procedure to install a hard disk drive in position 1:
1 Align the four feet on the bottom of the drive carrier with the square holes in the
storage tray, as shown in Figure 38.
Installing a Hard Disk Drive in Position 1 (Rear Position)
2 Set the drive in the storage tray.
3 Connect the power connector and the appropriate SCSI connector to the drive.
4 Push the drive toward the rear of the tray until the locking tab on the drive carrier
snaps into place, as shown in Figure 38.
5 Proceed to the section entitled Replacing the Storage Tray Cover on page 130.
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
129