B_configure.doc 163 Thu Jul 11 10:48:31 1996
Figure 65
3 Connect the FW SCSI controller to the CPU board by pressing firmly on the con-
nector area and near the standoffs to make sure that the FW SCSI controller is ful-
ly seated and that the standoffs are fully engaged with the FW SCSI controller.
4 Remove the storage tray cover by pressing in the two cover locking tabs then lift-
ing the front end of the cover and sliding it forward off of the pins in the rear, as
shown in Figure 65.
Removing the Storage Tray Cover
Changing Your Workstation's Hardware Configuration
Installing the Optional Fast Wide SCSI Controller
163