Configuring An Ide Device After Installation; Installing An Ide Hard Disk Drive In The Rear Shelf - HP Vectra XA 6/xxx User Manual

2 How to Install Accessories In Your PC
Installing Mass Storage Devices

Configuring an IDE Device After Installation

After installing a second IDE drive, or after installing any flexible disk
drive, you will need to verify that your PC has correctly identified the
new configuration, by viewing the HP Summary Screen. Refer to the
"HP Summary Screen", on page 53. If the configuration is not correct,
run the Setup program to configure the device. Refer to "Using the HP
Setup Program" on page 54, for details of how to do this.

Installing an IDE Hard Disk Drive in the Rear Shelf

The PC has an integrated Enhanced IDE controller which supports two
Fast IDE hard disk drives.
Refer to the drive's manuals to see if you must set jumpers or if there is
a special installation procedure to follow.
1 Disconnect the computer's power supply cord and any connection to
a telecommunications network.
2 Remove the computer's cover.
3 Slide the drive into the rear drive shelf, supporting the drive with
your hand.
4 Align the drive with the holes in the rear drive shelf. Then secure the
drive with the screws provided with it.
Step 3: Slide drive into
rear shelf
22 English
Step 4: Align the drive.