B_configure.doc 135 Thu Jul 11 10:48:31 1996
Installing Additional memory
Before installing memory modules, perform the procedure described in
Removing the Main Tray Assembly on page 109.
When you have completed changing your workstation's memory configura-
tion perform the procedure described in Replacing the Main Tray Assembly
on page 110.
Take a moment to read over the following important notes about installing
memory.
•
Before you attempt to install additional memory modules in your B132L/B160L
workstation, use the information described in Appendix D, "Boot Console Inter-
face," to determine the current memory configuration for this workstation.
•
Read over the steps involved in installing memory modules before you begin.
•
You must insert memory modules in pairs of equal size.
•
Modules should be inserted in the lowest numbered memory pair first then in nu-
merical order. For example, install memory in 0A and 0B first, then 1A and 1B,
and 2A and 2B. Refer to Figure 42 for memory pair numbering and location.
•
When you have finished installing additional memory modules, use the Boot
Console Interface to verify that they are seen by the workstation.
Changing Your Workstation's Hardware Configuration
Installing Additional memory
135