6. Slide the floppy disk drive and its bracket into the system unit
7. Plug the floppy power cable into its connector. Next, plug the data
Figure 5-28
Plugging In the Floppy Data and Power Cables
8. Tighten the two floppy disk drive bracket screws as shown in Figure
Figure 5-29
Tightening the Bracket Screws
Chapter 5
chassis as shown in Figure 5-27.
cable into its connector. Note that the connectors are keyed for proper
insertion. See Figure 5-28.
Power
Cable
Ferrite Bead
5-29. You will need to use 6 inch-pounds of torque to tighten them.
Bracket
Screw
Changing Your Computer Hardware Configuration
Data Cable
Removable Media Devices
Bracket
Screw
(hidden)
131