Searching For Bootable Media - HP Visualize B1000 Owner's Manual

Searching for Bootable Media

To list devices that contain bootable media, follow the directions in
"Accessing the Boot Console Interface" earlier in this chapter, and then
type the following at the prompt and press
Main Menu: Enter command> search ipl
The search command searches all buses. The search may turn up more
devices than there are lines on your display. If you are using a text
terminal, you may control the progress of the search from your terminal's
keyboard by using these keystrokes:
Temporarily suspends the search.
Ctrl S
Continues the search.
Ctrl Q
Any Other Key Stops the search.
These flow-control keystrokes do not work with a bitmapped display, but
such a display can show more than forty lines of text, so you are unlikely
to need them.
To search for devices of just one type that actually contain bootable
media, follow the directions in "Accessing the Boot Console Interface"
earlier in this chapter, and then type the following at the prompt and
press :
Enter
Main Menu: Enter command> search ipl device_type
where device_type is one of the following:
Is the built-in Ultra2 Wide LVD SCSI bus.
fwscsi
Is the built-in Fast Narrow Single-Ended SCSI bus.
scsi
Is all connections to the built-in LAN.
lan
Is an optional SCSI interface in slot number n .
pci n
Is a built-in IDE bus.
ide
Chapter 6
The Boot Console Interface
Searching for Bootable Media
:
Enter
177