Figure 5-22. Tightening The Bracket Screws; Figure 5-23. Replacing The Cd Drive Bay's Rear Cover - HP Visualize B1000 Owner's Manual

6. Tighten the two CD drive bracket screws as shown in Figure 5-22.
Figure 5-22 Tightening the Bracket Screws
Bracket
Screw
7. Place the audio, ATAPI and power cables inside the CD drive bay, and
Figure 5-23 Replacing the CD Drive Bay's Rear Cover
Rear Cover
Audio
Cable
Chapter 5
These should be tightened using 6 inch-pounds of torque.
position the cables so that they go under the bottom edge of the CD
drive bay's rear cover. The CD drive bay's rear cover's edge is rounded
to keep you from cutting the cables. See Figure 5-23. Next, place the
end opposite the rear cover handle into the cover slot, rotate it into
place, and tighten the T-15 Torx/slotted screw using 6 inch-pounds of
torque. This will secure the rear cover in place. See Figure 5-23. You
have completed the removal of the CD drive.
Rear Cover
Handle
Ferrite Bead
ATAPI Cable
Power Cable
Changing Your Computer Hardware Configuration
Removable Media Devices
Bracket
Screw
T-15
Torx/Slotted
Screw
125