Hard Disk Drives - HP Visualize B1000 Owner's Manual

Changing Your Computer Hardware Configuration

Hard Disk Drives

Hard Disk Drives
This section describes how to install a hard drive in your computer and
how to remove it from your computer. The first section details how to
install a hard disk drive. The second section details how to remove a
hard disk drive. The final section explains how to configure your hard
disk after it is installed.
Your computer can have two internal hard disk drives. These internal
hard disk drives are devices on the Ultra2 Wide Low-Voltage Differential
SCSI bus. The hard disk drive that came with your computer was set to
SCSI ID 6 on the Ultra2 Wide Low-Voltage Differential SCSI bus. If you
are adding a second internal hard disk drive, the second hard disk drive
will use SCSI ID 5 on the Ultra2 Wide Low-Voltage Differential SCSI
bus. Note that the two slots for the hard disk drives have SCSI ID
numbers 5 and 6 preassigned to them and SCSI ID 6 is the system disk.
You will not be able to change these SCSI ID numbers.
CAUTION Hard disk drives are susceptible to mechanical and electronic shock.
When handling the drive, always wear the static-grounding wrist strap
that came in the floppy disk drive kit. Always handle the drive carefully.
140 Chapter 5