Formatting A New Diskette - HP Visualize B1000 Owner's Manual

Using Your 3.5-Inch Floppy Disk Drive
Operating the Floppy Drive

Formatting a New Diskette

If you have floppy diskettes that have been previously formatted using
the mediainit utility, you can skip this section. Otherwise, you must
always format a new floppy diskette with the mediainit utility before
using the diskette. To format a new floppy diskette, follow these steps:
1. Log in as root.
2. Make sure that the write-protect tab on the floppy diskette is in the
write position, as shown in Figure 3-2.
3. Insert the diskette into the floppy disk drive.
4. Type the following at the prompt and press
mediainit -f 16 devicefile
where 16 is the High Density (HD) format option and devicefile is
the device file as listed by SAM. See the section "Using Device Files"
in this chapter. For a listing of format options, see the floppy manual
page. To view this manual page, type the following at the prompt and
press :
Enter
man floppy
74
:
Enter
Chapter 3