Figure 5-46 Installing Memory Cards - HP Visualize B1000 Owner's Manual

Changing Your Computer Hardware Configuration
Memory Cards
5. Press downward on the ejector tabs located on both sides of the
Figure 5-46 Installing Memory Cards
Notches
Step 2
6. Place the DIMM card in the connector, lining it up with the guides.
7. Press firmly and evenly on the DIMM card to ensure that it seats
8. Replace the left side panel as explained in the section "Closing the
9. Verify that this installation was successful by following the steps in
Once you have completed the steps listed above, your DIMM cards are
properly loaded.
156
DIMM connector. See Figure 5-46. This opens the connector for
DIMM card insertion.
Step 1
Black
Ejector Tab
Make sure you align the notches on the bottom edge of the DIMM
card with the DIMM connector keys. See Figure 5-46.
properly, and replace the hard disk drive fan as explained in the
section "Replacing the Hard Disk Drive Fan" in this chapter.
System Unit after Propping Up the Power Supply" in this chapter.
Plug the power cord back in to the electrical outlet.
the section "Displaying the Current Memory Configuration" in the
chapter "The Boot Console Interface" in this document.
Press down on ejector tabs to
open them and place the
DIMM card in the connector
so that your fingers are on
the edge of the DIMM card.
Push the DIMM card down
firmly and evenly into the
connector to be sure it is
properly seated.
White
Ejector Tab
Chapter 5