Step 15. Attach Hydraulics; A30-S And A30-D Headers - MacDon A30-S Assembly Instructions Manual

STEP 15. ATTACH HYDRAULICS

DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
B
a. Disengage rubber latch (A) and open driveline
shield (B).
E
b. Remove the cap (C) from electrical connector,
and remove connector from support bracket.
c. Disengage and rotate
clockwise to fully up position to release the hose
bundle (E).
d. Move hose bundle (E) to header.
e. Rotate lever (D) clockwise and engage in
bracket to store.
f. Refer to section A. or B. for hose attachment
details on your specific header model.
Form # 169078
UNLOADING AND ASSEMBLY
A
D
lever (D) counter-
A. A30-S AND A30-D HEADERS
The connections are the same for all M Series
tractors.
a. Route hoses (E) from tractor through support (F)
and access hole (G) in header frame.
b. Remove cover on header electrical receptacle
(H).
c. Push connector onto receptacle and turn collar
on connector to lock it in place.
d. Attach cover to mating cover on tractor wiring
harness.
e. Remove caps from hydraulic couplers and clean
if necessary.
CASE DRAIN
HEADER DRIVE
C
f. Push hose connectors onto mating receptacles
as shown until collars on receptacles snap into
lock position.
g. Close driveline shield before engaging header.
h. Proceed
HEADER.
18
E
F
H
G
RETURN
to STEP 16. LUBRICATE THE
Model Year - 2009