Step 2. Remove Underside Shipping Stand; Step 3. Install Additional Skid Shoes - MacDon A30-S Assembly Instructions Manual

STEP 2. REMOVE UNDERSIDE
SHIPPING STAND
CAUTION
Keep feet clear when removing final bolts.
A
a. Remove four bolts (A) and remove shipping
stand (B). Discard stand and hardware.
STEP 3. INSTALL ADDITIONAL
SKID SHOES
If kit not supplied, proceed to STEP 4. INSTALL
GAUGE ROLLERS, otherwise proceed as
follows:
This kit may be installed later in the
header assembly sequence but it may be
easier prior to laying the header down.
a. Unpack skid shoe bundle.
D
b. Remove two clevis pins (C) from each skid
shoe.
c. Remove nuts, bolts, and clips (D) from skid
shoe.
Form # 169078
UNLOADING AND ASSEMBLY
A
B
NOTE
C
d. Insert tabs on skid shoe into slots (E) on
cutterbar at inboard mounting locations on frame
and secure with clevis pin (C).
e. Attach clips (D) with bolts and nuts removed at
step c. to secure skid shoe to cutterbar.
Use a socket and ratchet wrench to
access the nuts.
f. Remove clevis pin (C) and adjust skid shoe to
desired height.
and secure with lynch pins.
g. Repeat above steps for opposite side. Set both
skid shoes to same position.
8
E
D
C
NOTE
Re-install two clevis pins (C)
Model Year - 2009
C