A40-D Header - MacDon A30-S Assembly Instructions Manual

B. A40-D HEADER
The header drive connection only powers the
knife and hay conditioner on the A40-D header
(knife only on grass seed header).
connections are required for the auger and reel
as follows:
B
E
a. Route hoses (A) from tractor through support (B)
and access hole (C) in header frame alongside
existing hose bundle (D).
b. Remove cover on header electrical receptacle
(E).
c. Push connector onto receptacle and turn collar
on connector to lock it in place.
d. Attach cover to mating cover on tractor wiring
harness.
e. Remove caps from hydraulic couplers and clean
if necessary.
REEL &AUGER
KNIFE &
CONDITIONER
RETURN
CASE DRAIN
STANDARD HEADER
f. Push hose connectors onto mating receptacles
as shown until collars on receptacles snap into
lock position.
Form # 169078
UNLOADING AND ASSEMBLY
Separate
C
D
PRESSURE
KNIFE &
CONDITIONER
PRESSURE
KNIFE RETURN
(MALE FITTING
AT HEADER)
A
CASE DRAIN
g. Open header L H drive shield.
h. Check hose routing at the reel motor and ensure
it is as shown, depending on which tractor the
header is being attached to. Change hoses as
shown if header is being mounted on a M100
tractor.
19
KNIFE PRESSURE
(FEMALE FITTING
GRASS SEED HEADER
HOSE ROUTING – M150/M200
(FACTORY CONFIGURATION)
HOSE ROUTING – M100
(continued next page)
AUGER & REEL
PRESSURE
AT HEADER)
Model Year - 2009