Step 16. Attach Hydraulics - MacDon A30-S Unloading And Assembly Instructions

STEP 16. ATTACH HYDRAULICS

A. A30-S
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
B
a. Disengage rubber latch (A), and open driveline
shield (B).
E
D
b. Remove cap (C) from electrical connector, and
remove connector from support bracket.
c. Disengage and rotate lever (D) counterclockwise
to fully up position to release hose bundle (E).
169078
UNLOADING AND ASSEMBLY
A
C
E
d. Move hose bundle (E) to header.
e. Rotate lever (D) clockwise, and engage in
bracket to store.
If the hose bundle contains four hoses
(draper header operation), only three are
required to power the A30 header.
Ensure loose hose is properly secured to
avoid contact with the drivelines.
E
H
f. Route hoses (E) from windrower through
support (F) and access hole (G) in header
frame.
g. Remove cover on header electrical receptacle
(H), push connector onto receptacle, and turn
collar on connector to lock it in place.
h. Attach cover to mating cover on windrower
wiring harness.
i. Remove caps (if installed) from hydraulic
couplers, and clean if necessary.
31
D
NOT USED
IMPORTANT
F
G
(continued next page)
Revision E