Step 9. Adjust Lean Bar; Step 10. Adjust Pan Extensions - Grass Seed Special; Step 11. Adjust Transport Lights - MacDon A30-S Assembly Instructions Manual

STEP 9. ADJUST LEAN BAR
a. Lean bar is fully retracted for shipping. Remove
hardware on both sides and install lean bar in
field position at position suitable for crop.
b. Proceed to STEP 11. ADJUST TRANSPORT
LIGHTS. If Grass Seed Header, proceed as
follows:
STEP 10. ADJUST PAN
EXTENSIONS – GRASS
SEED SPECIAL
The grass seed header auger pan extensions
are factory installed for the widest delivery
opening. Adjust as follows:
A
a. Remove two bolts (A), and loosen bolt (B).
b. Slide pan extensions (C) and swath forming rods
inboard to desired position and align holes.
Form # 169078
UNLOADING AND ASSEMBLY
WIDE
C
B
c. Re-install two bolts (A) and tighten bolts (A) and
(B).
d. Repeat for opposite pan extension.
STEP 11. ADJUST TRANSPORT
LIGHTS
a. Position amber light supports perpendicular to
header.
b. Check that pivot bolt is tight enough to hold light
support in upright position yet allow light to pivot
out of the way of obstructions.
Do not over tighten mounting hardware.
c. Ensure base of light housings and bolted
connections on light supports provides proper
electrical grounding.
13
NARROW
A
B
NOTE
Model Year - 2009
C